Product Description
Resin Force PolyGlow Metallic is a two-component, 100% solids, VOC compliant, extended working time aliphatic polyaspartic developed specifically for UV stable Metallic Floors. Ideal for warm, humid, where an extended working time top coat is needed.
COVERAGE RATE:
- Primer Direct to Concrete: 150-265 sq ft per gallon
- Metallic Design Coat or Clear Flood Coat: 50-75 sq ft per gallon
- Top Coat over Full Broadcast Flake Floors: 130-200 sq ft per gallon
- Grout Coat over Full Broadcast Quartz: 100-150 sq ft per gallon
PROPERTIES:
Based on 71°F @ 50% RH*
Working Time.........35-40 Mins Pot Life................40-50 Mins
Tack Free...............1-2 Hours Re-Coat Time.......6-10 Hours
Light Traffic...........24-48 Hours Full Cure..............2-3 Days
MIXING: Pre-mix Part A and Part B separately for 1-2 minutes prior to combining components together. Pour 1
Part of Part B into 1 Part of Part A by volume, then mix with a helix or jiffy mixer for 3 minutes at 300-450 RPM at low speed scooping sides, bottom, and all around for a good uniform mix.
Avoid high speed which will cause entrapment of air during mixing. Be sure to scrape the walls and bottom of container with straight-edged trowel or mixing stick at least once to ensure homogeneous mix. Do not mix more material than can be
applied within working time limits. Immediately pour contents out of the pail onto the floor to begin spreading.
APPLICATION: Apply mixed material by pouring onto the surface and spread with a flexible squeegee, lint free
roller, or T-Bar. Use a brush or small roller for edges, corners, and other hard to reach areas. If the material
becomes thick while applying and sticking to the application tools, stop applying and discard the mixed material.
*Clean-up tools and equipment with Xylene.
Hot surfaces may accelerate gel time of the product. If applying multiple thin coats, at 5-10 mils per coat, apply the second coat as soon as the first coat can be walked on; 1-4 hours. If recoat window is exceeded, sand to 100% abrasion, wipe with acetone, and recoat.
FOR PROFESSIONAL USE ONLY! Refer to TDS for more information.
